Dry Dusting (Routine Cleaning)
This is the preferred cleaning method for toothbrush embroidery crafts; it involves no water, thereby maximizing protection for the raised embroidery surface.
Use a soft goat-hair brush or makeup brush to gently sweep the surface in the direction of the raised embroidery threads, removing surface dust; avoid brushing forcefully against the grain.
Use an air blower to target the crevices of the embroidery, dislodging and removing accumulated dust from deep within.
Finally, gently roll a lint roller over the surface to pick up any remaining loose fibers or tiny debris; use a light touch and do not press down hard.
Spot Cleaning (Targeted Stain Removal)
Use this method only for small, localized stains to avoid damaging the piece by submerging it in water.
Prepare warm water (below 30°C) mixed with a tiny amount of neutral laundry detergent or wool wash, stirring until a fine foam forms.
Dip a cotton swab into a small amount of foam and gently dab or wipe only the stained area; avoid spreading the foam onto the surrounding clean embroidery.
After cleaning, use a clean cotton swab dampened with plain water to repeatedly wipe away any detergent residue, preventing chemical damage to the embroidery threads.
Gently blot dry with a paper towel and allow the item to air-dry in a cool, well-ventilated place; do not use a hair dryer directly on the piece.





